From 12:00 PM - 4:00 PM CST on Thursday, October 18, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Table Of Contents

ni579x Configure Attenuation (G Dataflow)

Last Modified: January 9, 2017

Configures the attenuation level and returns the coerced attenuation level.

connector_pane_image
datatype_icon

scope

Specifies the mixer to configure. Valid values are rx/atten1, rx/atten2, and tx.

datatype_icon

Register Bus

Register Bus object created by ni579x Open and used as the session handle for the NI-579x Configuration nodes.

datatype_icon

attenuation [dB]

Specifies the attenuation, in dB, in the stopband. If attenuation is less than or equal to 0, the node returns 0 as well as an error.

datatype_icon

Error In

Error conditions that occur before this node runs. Use this information to decide whether to bypass any functionality if this node receives errors from other nodes.

datatype_icon

Register Bus (out)

The Register Bus object created by ni579x Open and used as the session handle for the NI-579x Configuration nodes.

datatype_icon

coerced attenuation [dB]

Returns the actual attenuation, in dB.

datatype_icon

Error Out

Information about errors or warnings that occurred during or before the execution of this node.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics