Estimates the Butterworth filter order.
The type of filter that this node creates.
Creates a lowpass filter.
Creates a highpass filter.
Creates a bandpass filter.
Creates a bandstop filter.
The sampling frequency in Hz.
This value must be greater than zero.
Default: 1.0 Hz, which is the normalized sampling frequency
Band edge frequencies of the filter, in Hz.
First passband edge frequency in hertz.
First stopband edge frequency in Hz.
Second passband edge frequency in Hz. The node ignores this input for lowpass and highpass filters.
Second stopband edge frequency, in Hz. The node ignores this input for lowpass and highpass filters.
Ripple level in the passband and stopband of the filter.
Ripple level in the passband.
Ripple level in the stopband.
A Boolean value that specifies whether this node applies a decibel scale or a linear scale to the ripple levels.
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default: no error
Minimum order value that the filter requires to meet the specifications you set.
High cutoff frequency. The cutoff frequency corresponds to the half-power frequency or the 3 dB frequency.
Low cutoff frequency. The cutoff frequency corresponds to the half-power frequency or the 3 dB frequency.
The node produces this output according to standard error behavior.
Installed By: LabVIEW Communications System Design Suite (introduced in 1.0)
Where This Node Can Run:
Desktop OS: Windows
FPGA: Not supported