Home > Support > NI Product Manuals > LabVIEW Communications System Design Suite 1.0 Manual

Calculates the maximum possible peak amplitude, after pulse-shape filtering and resampling, of a waveform. This calculation is based on system parameters for the ASK modulation scheme.

connector_pane_image
datatype_icon

ASK system parameters

Parameter values defining the ASK system. Wire the ASK system parameters cluster of MT Generate ASK System Parameters (M) or MT Generate ASK System Parameters (map) to this cluster. Do not alter the values.

datatype_icon

samples per symbol

An even number of samples dedicated to each symbol. Multiply this value by the symbol rate to determine the sample rate.

Note  

The demodulation and detector nodes use timing recovery, which is optimized for four or more samples per symbol.

Default: 16

datatype_icon

symbol map

An ordered array that maps each symbol to its desired level. The number of ASK levels in the array is 2 N , where N is the number of bits per symbol. The vector length for the symbols farthest from the origin is 1.

datatype_icon

pulse shaping filter coefficients

An ordered array of filter coefficients corresponding to the desired filter response for the pulse-shaping filter used in modulation. The number of coefficients depends on the pulse-shaping filter characteristics specified in the pulse-shaping filter. Refer to MT Generate Filter Coefficients for more information about pulse-shaping filter coefficients.

datatype_icon

error in

Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

Default: no error

datatype_icon

waveform scaling factor

Inverse of the maximum amplitude of the I/Q waveform based on the specified system parameters.

For the frequency modulation schemes (FSK, MSK, and CPM), there is no known analytical method to calculate the maximum amplitude that accounts for effects such as resampling, filtering, and so on. Empirically, a waveform scaling factor of 0.8 should be sufficient for most of your applications. This value results in a maximum dynamic range loss of about 2 dB on third-party (non-NI) RF signal generator devices.

If you receive errors related to this value, your signal might be aliased. For more information about aliasing, refer to MT Modulate CPM or MT Modulate FSK.

datatype_icon

error out

Error information. The node produces this output according to standard error behavior.