Home > Support > NI Product Manuals > LabVIEW Communications System Design Suite 1.0 Manual
Version:

    The following figure shows the location and pinouts for the IEEE 1284 (parallel) connector on the NI PXIe-8133. The following table lists and describes the IEEE 1284 connector signals.

    Parallel port adapter cables are available from National Instruments, part number 777169-01.

    Figure 1. Parallel Port Connector Location and Pinout
    Table 1. Parallel Port Connector Signals
    Pin Signal Name Signal Description
    1 BUSY Device Busy
    2 SLCT Select
    3 ACK# Acknowledge
    4 FAULT#(ERROR#) Fault
    5 PAPEREND Paper End
    6 PD0 Data Bit 0
    7 PD1 Data Bit 1
    8 PD2 Data Bit 2
    9 PD3 Data Bit 3
    10 PD4 Data Bit 4
    11 PD5 Data Bit 5
    12 PD6 Data Bit 6
    13 PD7 Data Bit 7
    14 INIT# Initialize Printer
    15 STROBE# Strobe
    16 SLCTIN# Select Input
    17 AUTOFD# Auto Line Feed
    18 +5V +5 V
    19-35 GND Ground
    36 NC Not Connected
    Note  

    The pound symbol (#) indicates an active low signal.