Home > Support > NI Product Manuals > LabVIEW Communications System Design Suite 1.0 Manual
Version:

    The following figure shows the location and pinouts for the GPIB connector on the NI PXIe-8133. The following table lists and describes the GPIB connector signals.

    ITT Canon manufactures a GPIB mating connector, part number MDSM-25SC-Z11-V51.

    Figure 1. GPIB Connector Location and Pinout
    Table 1. GPIB Connector Signals
    Pin Signal Name Signal Description
    1 DIO1# Data Bit 1
    2 DIO2# Data Bit 2
    3 DIO3# Data Bit 3
    4 DIO4# Data Bit 4
    5 EOI# End or Identify
    6 DAV# Data Valid
    7 NRFD# Not Ready for Data
    8 NDAC# Not Data Accepted
    9 IFC# Interface Clear
    10 SRQ# Service Request
    11 ATN# Attention
    12 SHIELD Chassis ground
    13 DIO5# Data Bit 5
    14 DIO6# Data Bit 6
    15 DIO7# Data Bit 7
    16 DIO8# Data Bit 8
    17 REN# Remote Enable
    18-25 GND Logic Ground
    Note  

    The pound symbol (#) indicates an active low signal.