Home > Support > NI Product Manuals > LabVIEW Communications System Design Suite 1.0 Manual

Use this synchronization method in conjunction with the ni579x FPGA Align node on the FPGA to synchronize the FPGAs. Refer to the FPGA nodes for documentation.

Input Parameters

  • Register Buses—Specifies the Register Buses to which the Synchronization library is connected in the FPGA nodes.
  • sync.cptr.period—The period, in clocks, of the Common Periodic Time Reference (CPTR). The CPTR period controls the rate at which synchronized signals are realized. This parameter is required, and you must specify a value for each target to be synchronized. When using ni579x FPGA Align, the CPTR period must be the same as the Reference Clock period. The sync.cptr.period must be set to the ratio of the Clock-Driven Loop (CDL) rate (that the Align node is in) to the sync.meas.Reference Clock rate. For example, the CPTR period must be 13 if you are using PXI_Clk10 for the Reference Clock, and the IO Module\Sample Clock for the CDL clock (130 MHz / 10 MHz). When using ni579x Host Align, this value is configurable. The maximum value is 63. The minimum value for sync.cptr.period must be large enough to ensure transmission across the sync.cptr.FPGA I/O line. Refer to the specifications for the FPGA I/O line that you choose. For example, if the FPGA I/O line has a maximum propagation delay of 50 ns, the minimum value is 7 (the period of the 130 MHz IO Module\Sample Clock is approximately 7.692 ns, so 7 clocks are required to exceed 50 ns). NI does not recommend changing the CPTR period on-the-fly. Alignment must be re-run if you change the CPTR period.
  • error in—Describes error conditions that occur before this node runs. This input provides standard error in functionality.

Output Parameters

  • Register Buses (out)—Passes the Register Buses to the next node.
  • error out—Contains error information. This output provides standard error out functionality.

Installed By: LabVIEW Communications System Design Suite (introduced in 1.0)

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported