Home > Support > NI Product Manuals > LabVIEW Communications System Design Suite 1.0 Manual
Version:

    The following table shows the front panel connector and signal descriptions for the NI 5792.

    Caution  

    To avoid permanent damage to the NI 5792, disconnect all signals connected to the NI 5792 before powering down the module, and connect signals only after the adapter module has been powered on by the NI FlexRIO FPGA module.

    Caution  

    Connections that exceed any of the maximum ratings of any connector on the NI 5792R can damage the device and the chassis. NI is not liable for any damage resulting from such connections.

    Table 1. NI 5792 Front Panel Connectors
    Device Front Panel Connector Signal Description
    RX IN Receive channel input, +20 dBm maximum
    LO OUT Local oscillator output, +12 dBm maximum, +0 dBm nominal
    CLK IN Reference Clock input, 50 Ω single-ended, +20 dBm maximum
    CLK OUT Exported clock output, DC-coupled, 0 V to 2 V
    LO IN Local oscillator input, +20 dBm maximum
    AUX I/O Refer to the table below for signal list and descriptions.

    For more detailed information about the NI 5792 front panel connectors, refer to the NI 5792R Specifications.