Table Of Contents

IviRFSigGen Configure Power Step Start Stop [PST] (G Dataflow)

Version:
    Last Modified: October 24, 2017

    Configures the settings that control the power steps of the generator's RF output signal. These settings are start and stop power and step size. If the stop power is less than the start power, the power decreases in value during the sweep

    connector_pane_image
    datatype_icon

    stop (-10.0)

    Specifies the start power of the stepped sweep. If the stop power is less than the start power, the power decreases in value during the sweep. The driver uses this value to set the IviRFSigGen>>Sweep>>Power Step>>Power Step Stop property. Units: dBm Default Value: -10.0

    datatype_icon

    start (-50.0)

    Specifies the start power of the stepped sweep. If the stop power is less than the start power, the power decreases in value during the sweep. The driver uses this value to set the IviRFSigGen>>Sweep>>Power Step>>Power Step Start property. Units: dBm Default Value: -50.0

    datatype_icon

    instrument handle out

    The instrument handle that you obtain from the IviRFSigGen Initialize Node or IviRFSigGen Initialize With Options Node. The handle identifies a particular instrument session.

    Default: None

    datatype_icon

    error out

    Error information.

    The node produces this output according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.
    datatype_icon

    error in

    Error conditions that occur before this node runs.

    The node responds to this input according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Default: No error

    datatype_icon

    instrument handle

    The instrument handle that you obtain from the IviRFSigGen Initialize Node or IviRFSigGen Initialize With Options Node. The handle identifies a particular instrument session.

    Default: None

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported

    Web Server: Not supported in VIs that run in a web application


    Recently Viewed Topics