Table Of Contents

Configuring Data Rate Values

Last Modified: September 14, 2018

You can configure the data rate at which your DAQ device acquires data by customizing the data ranges and setting the values for slow, medium, and fast data rate levels.

Complete the following steps to configure the available data rates for your DAQ device:

  1. Select the Configure Data Rates from the toolbar, or click Configure from the Configure Data Rates dialog.
  2. Specify each frequency in Hz or s (seconds, for intervals) for the desired slow, medium, and fast rates.
  3. Click OK to apply the rates for the module.
spd-note-notice
Notice  

You can configure any analog input device to use Slow, Medium, or Fast data rates. Counter input modules, however, require the use of a data rate resource also used by the Medium data rate resource. If a counter input module is added to your system and all Medium data rate resources are in use, you will be prompted to change the data rate on another module in the system to free the required resource for use.


Recently Viewed Topics