From 6:00 PM CST Friday, Feb 15th - 2:00 AM CST Sunday, Feb 17th, will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Table Of Contents

Using Probes to Check Values on a Wire

Last Modified: December 2, 2016

With execution highlighting, you can see data values at a slower execution speed. However, you may want to monitor specific data values without needing to slow execution. You can use probes on specific wires to determine if and where unexpected data occurs.

A probe displays the data from the wire both on the probe itself and also in the Debugging tab when the wire executes. The data remains visible until the same wire executes again.

Add a probe to a wire by right-clicking a wire and selecting Set Probe.

Recently Viewed Topics