Data Type Changes on FPGA
When you add this node to a document targeted to an FPGA, this input has a default data type that uses fewer hardware resources at compile time.
Behavior for Out of Range Values
If index for any dimension is less than zero or greater than the length of array in that dimension, this node returns the default value of the defined data type for the array.
Relationship between index Inputs and array Dimensions
For multidimensional arrays, index inputs correspond to row-major order. Thus, the first index corresponds last dimension of the array input, and the last index corresponds to the first dimension of the array input. The following table shows the relationship between four index inputs and the dimensions of a 4D array input.
|index Order||Corresponding Dimension in array Input||index Name|
Unwired Index Inputs
Unwired index inputs allow you to retrieve a subarray of the array rather than a single element. For example, to retrieve column 1 of a 2D array, specify 1 in the column index and leave the row index unwired.
When all index inputs are unwired, the retrieved subarray contains one less dimension than array.
Relationship between index and Multiple element or subarray Outputs
If you expand the node to show more than one element or subarray output, the node provides a set of index inputs for each output. The values you wire to a set of index inputs determine the value of the corresponding output. However, if you do not wire values to a set of index inputs, the corresponding element or subarray output returns the element or subarray that follows the previous element or subarray output in the original array. Refer to the Examples tab for an illustration of this relationship.
The waveform whose array of y values you want to use in this operation. This input becomes available when you wire a waveform to array.
When you wire an array to this node, the node resizes automatically to display index inputs for each dimension in the array you wire to array. You also can add additional element or subarray outputs by resizing the node. The node provides index inputs for each output.
You can disable indexing along a dimension by leaving the corresponding index input unwired. By default, the first dimension has indexing enabled, with the others disabled. You can wire a constant or control to the index inputs that you want enabled.
For example, if you want to index a row in a 2D array, the first index input is enabled and the second index input is disabled. If you want to index that same 2D array also by column, you can resize the node to show another set of input terminals. This next set of inputs has its own corresponding element output. By default, if you do not wire any index input terminals, the first element indexes row 0, the second element indexes row 1, and so on.
The following image illustrates this node's behavior for a variety of inputs:
|element, all indexes wired|
|subarray, row wired||Without a value for the column dimension, Index Array returns the entire row specified by the row input.|
|subarray, indexes unwired||This output has no values specified for its corresponding row and column inputs. Therefore, the node returns the subarray that immediately follows the previous output.|
|subarray, column wired||Without a value for the row dimension, Index Array returns the entire column specified by the column input.|
Where This Node Can Run:
Desktop OS: Windows
FPGA: DAQExpress does not support FPGA devices