Table Of Contents

Single Pulse Generation with Start Trigger

Version:
    Last Modified: February 26, 2018

    The counter can output a single pulse in response to one pulse on a hardware Start Trigger signal. The pulse appears on the Counter n Internal Output signal of the counter.

    You can specify a delay from the Start Trigger to the beginning of the pulse. You also can specify the pulse width. The delay is measured in terms of a number of active edges of the Source input.

    You can specify a pulse width. The pulse width is also measured in terms of a number of active edges of the Source input. You can also specify the active edge of the Source input (rising and falling).

    The following figure shows a generation of a pulse with a pulse delay of four and a pulse width of three (using the rising edge of Source).

    Figure 1. Single Pulse Generation with Start Trigger

    Recently Viewed Topics