Table Of Contents

Rear Mounting the cRIO-905x on a Flat Surface

Version:
    Last Modified: October 29, 2018

    Complete the following steps to rear mount your cRIO-905x directly on a flat surface.

    What to Use

    • cRIO-905x
    • M4 screws, user provided, which must not exceed 8 mm of insertion into the cRIO-905x
      • x4 for 4-slot models
      • x6 for 8-slot models

    What to Do

    Complete the following steps to rear mount the cRIO-905x directly on a flat, rigid surface using the mounting holes.

    spd-note-note
    Note  

    NI recommends surface mounting your system in environments with high shock and vibration.

    Figure 1. Rear Mounting the 4-slot cRIO-905x Directly on a Flat Surface
    Figure 2. Rear Mounting the 8-slot cRIO-905x Directly on a Flat Surface
    1. Prepare the surface for mounting the cRIO-905x using the cRIO-905x Surface Mounting Rear Dimensions.
    2. Align the cRIO-905x on the surface.
    3. Fasten the cRIO-905x to the surface using the M4 screws appropriate for the surface.
      spd-note-note
      Note  

      Screws must not exceed 8 mm of insertion into the cRIO-905x. Tighten the screws to a torque of 1.3 N · m (11.5 lb · in.).


    Recently Viewed Topics