Table Of Contents

Mounting the cRIO-905x on a DIN Rail

Version:
    Last Modified: October 29, 2018

    Complete the following steps to mount your cRIO-905x on a DIN rail.

    What to Use

    • cRIO-905x
    • Screwdriver, Phillips #2
    • NI DIN rail mounting kit
      • 4-slot models - 157254-01
        • DIN rail clip
        • M4 x 10 screws (x2)
      • 8-slot models - 157268-01
        • DIN rail clip
        • M4 x 10 screws (x3)

    What to Do

    Complete the following steps to mount the cRIO-905x on a standard 35-mm DIN rail.

    Figure 1. Mounting the 4-slot cRIO-905x on a DIN Rail
    Figure 2. Mounting the 8-slot cRIO-905x on a DIN Rail
    1. Align the DIN rail clip with the mounting holes on the rear of the cRIO-905x.
    2. Fasten the DIN rail clip to the cRIO-905x using the screwdriver and M4 x 10 screws.
      spd-note-note
      Note  

      You must use the screws provided with the NI DIN rail kit because they are the correct depth and thread for the DIN rail clip. Tighten the screws to a torque of 1.3 N · m (11.5 lb · in.).


    Recently Viewed Topics