Table Of Contents

Verify the System IP Configuration

Version:
    Last Modified: August 30, 2018

    Complete the following steps to verify the system IP configuration of your cRIO-905x

    1. Put the cRIO-905x in safe mode and enable the Console Out feature of the USB Type-C Device Port with Console Out by holding the RESET button down for 5 seconds.

      The STATUS LED starts blinking three times every few seconds.

      spd-note-note
      Note  

      Refer to cRIO-905x LEDs in the Features section for more information about your device LEDs.

    2. Use the USB Type-C Device Port with Console Out terminal to read the IP address.
      spd-note-note
      Note  

      Refer to cRIO-905x Ports and Connectors in the Features section for more information about port configuration.

    3. Set a new DHCP connection by holding the RESET button down for 5 seconds. The STATUS LED repeats the same behavior from Step 1. If the cRIO-905x fails to set a new DHCP address, it assigns itself a link-local IP address. If the DHCP connection is successful and appropriate for your application, skip to Step 6.
    4. In MAX, expand your system under Remote Systems.
    5. Select the Network Settings tab to configure the IP and other network settings.
    6. Reboot the cRIO-905x by pressing the RESET button.

    Recently Viewed Topics