Table Of Contents

Installing Software on the cRIO-904x

    Last Modified: March 2, 2018

    Complete the following steps to install software on the cRIO-904x.

    1. In MAX, expand your system under Remote Systems.
    2. Right-click Software.
    3. Select Add/Remove Software to launch the LabVIEW Real-Time Software Wizard.

      You must log in to install software on the cRIO-904x. The default username for the cRIO-904x is admin. There is no default password for the cRIO-904x. To set a password for your system, refer to Setting a System Password.

    4. Select the recommended software set for your LabVIEW and NI-RIO Device Drivers versions.
    5. Click Next.
    6. Select any additional software from the list of software add-ons, if needed.

      You can use this wizard at any time to install additional software.


      LabVIEW FPGA Module is required to run your modules in the LabVIEW FPGA program mode. NI Scan Engine is required to run your modules in the Real-Time Scan (IO Variables) program mode.

    7. Click Next.
    8. Verify that the summary of software to install is correct.
    9. Click Next to start the installation.
    10. Click Finish when the installation is complete.

    Recently Viewed Topics