Quanser RCP Toolkit Download

Überblick

The Quanser Rapid Control Prototyping (QRCP) toolkit is add-on software for LabVIEW. This powerful control design tool spans the spectrum of design, from simulation to control implementation. QRCP significantly simplifies access to Quanser control experiments by supporting all standard low-level software and hardware configurations, including hardware interfacing, inter-controller communications, and porting control code between control hardware. The resulting VIs match standard system block diagrams to help bridge the gap between theory and practical implementations. QRCP provides ease and speed for control design programming in LabVIEW to significantly shorten the controller development cycle and expands LabVIEW Control Design and Simulation Module capabilities. With compatibility and support for myRIO, CompactRIO, and NI PXI, QRCP offers a platform for teaching and performing advanced controls research using LabVIEW.

 

The Quanser RCP Toolkit provides the following:

  • Significantly simplifies setup and interfacing of Quanser control experiments
  • Allows for easier and faster control design programming in LabVIEW
  • Targets myRIO-, CompactRIO-, and Windows-based controllers with a single VI
  • Protocol-independent VIs support TCP/IP, UDP, shared memory, RS232 serial communication
  • Supports over 20 DAQ devices from NI and Quanser and 25+ Quanser control experiments
  • Must be used with the LabVIEW Control Design and Simulation Module

Download the latest version of the RCP toolkit

Download

Visit Here for getting started material

 

Back to top